There comes a time when wheels get damaged to a great degree. This may happen to many reasons. When a car is brushed off against a hard surface like a concrete wall or a metal body then the blunt blow is enough to damage wheels to a great degree. During such time it cannot be repaired in normal ways and more advanced methods are needed.

Diamond Cut Wheel Repair is one of the repairing methods during such time. It is capable of repairing the wheels where the damage is considerable and alarming. For instance if metal chunks of the wheel kerb is torn off due to the damage, most other methods may not be able to repair it. But the diamond cut wheel repairing method can do it easily.

In this method the parts of the alloy wheel are first separated. The rubber wheel, the semi circular large metal cap in the middle of the wheel, the ring is all removed till only the metal kerb or the alloy wheel is left. This alloy ring is then treated in a chemical solution to prevent further corrosion. Before the actual process can start the metal alloy kerb ring is then dried by machines fast. The wheel is later placed under a lathe which is used to slice of the part of the metal which is damaged. This is done so that after the part of the metal is machined off the effect is that of smooth surface finish. The Diamond Wheels Repaired is finally varnished and lacquered to further protect it from corrosion.

If one has seen wheels where some parts of it, or the entire sections of it have very fine lines on it and are very shiny then it is the effect of the diamond cur repairing. An advantage of the Diamond cut process is that it machines off the sharp allow metal pieces which stick out from the surface. Left of it own these can prove to be harmful in case of accidents. That is why this process should be done as soon as possible after a car accident or after any damage to the wheels.

A common question asked is how long the process can take. It depends on the extent of the damage to the metal. After the repairing process is complete it should be kept in mind that if the lacquer layer is damaged in some way then water will seep in and make milky patches on the diamond finished metal.

This method is fast and very effective. Also the effects of the Diamond Cut Alloy Wheels are long lasting.