- 1). Unpack your T300 plasma stand and lay the components out. Place the base plate of the stand where you would like to set up the unit.
- 2). Insert the two metal rods, threaded ends first, into the center of the two metal discs on the front corners of the base plate. Screw the rods into the metal rings to form the front supports.
- 3). Slide the metal cylinders over the rods.
- 4). Take the backboard of the stand and place it so that the studs on the bottom corners of the backboard line up with the studs at the back corners of the base plate. Press the backboard into the base plate.
- 5). Turn the unit on its side and insert the four included wheel pieces into the holes on the bottom corners of the unit. Press the wheels in firmly until they snap in place. Stand the unit back up.
- 6). Take the glass top of the stand and line up the four holes on the corners with the metal rods on the front of the base plate and the studs sticking out of the corners at the top of the backboard. The holes on the front of the top piece will connect with the top bit of exposed metal rods on the front and the studs in the back.
- 7). Slide the two small pieces of glass shelving into the grooves in the front cylinders until they connect with the grooves in the back panel. The shelves will now be formed and they will support DVD players or other small electronic devices.
previous post
next post